HP Z400 Maintenance And Service Manual page 121

d.
(If installing side access panel sensor) Carefully route the side access panel sensor cable
along the drive bay and plug it into the HSENSE connector on the system board (4).
NOTE:
Figure 5-36
12. Make sure that none of the cables are pinched by the fan holder/card guide assembly.
13. Replace components removed during this procedure: )
a.
Replace the front bezel (see
b.
Replace any expansion cards that you removed (see
on page
slots in the fan holder/card guide will now help secure any full-length expansion cards.
c.
Replace the side access panel (see
ENWW
To locate system board components, see the service label on the side access panel
Installing the fan holder/card guide assembly
Installing the front bezel on page
127), making sure that the cables will not interfere with the expansion cards. The
Installing an expansion card
Installing the side access panel on page
Removing and installing components
83).
78).
109