HP Z400 Maintenance And Service Manual page 48

Table 4-1
Heading
36 Chapter 4 System management
Computer Setup (F10) Utility menu descriptions (continued)
Option Description
Storage Options Provides these options:
●
●
●
●
DPS Self-test Select a drive—Lets you select a drive to test. (Available in SATA IDE emulation
mode only.)
The DPS self-test function directs an IDE hard disk to run an internal self-test and
report the results. If the SATA controller is not in IDE emulation mode, the DPS
self-test option is not displayed in the setup menu.
This selection appears only when at least one drive capable of performing the
IDE DPS self-test is attached to the workstation. By default, the SATA controller is
in RAID+AHCI mode, so this option is not displayed
Removable Media Boot—Enables and disables the ability to start the
workstation from removable media.
Legacy Diskette Write—Enables and disables the ability to write data to
removable media.
SATA Emulation—Sets the SATA emulation mode with the following
options:
RAID + AHCI—both the RAID and AHCI OPROMs execute. This
◦
emulation mode is the default and offers the best performance and
most functionality.
IDE —offers standard SATA supports (four ports only).
◦
SATA PORT 0-n—enables and disables the SATA ports. Offers these
configurations:
GEN 2/3.0 Gbps (Internal Only/eSATA Only)
◦
GEN 1/1.5 Gbps (eSATA Only)
◦
ENWW