Log-In And Configuration; Set Or Verify Network Address - GE MDS entraNET 900 Technical Manual

24
• hardware flow control disabled
• VT100 emulation
NOTE: The exact parameters given above must be used for console
terminal communication. Improper settings are a common
cause of difficulty.
Figure 2-6. Remote Configuration Setup
3. Press several times to receive the
ENTER
/ LED blinks to indicate data communication).
COM1 ETH
4. At the prompt, enter
entranet>
5. At the next prompt, enter the username (the default username is
). Press
admin
ENTER
6. At the next prompt, enter the password (the default password is
). Press
admin
ENTER

Set or Verify Network Address

The only setting normally required for initial checkout of a Remote
radio is the network address. All radios in a given network must be
programmed with the same network address as the AP, or
communication is impossible. Follow the steps below to check the
address, and program a new one if necessary.
1. Enter the
RADIO NETADDR=
programmed network address.
2. If changes are required, enter the
mand, where
<netaddr>
work address of the Remote radio must match that of the AP).
3. Verify that the
LINK
with the AP (it might take several seconds for the LED to light).
MDS entraNET Technical Manual
Invisible place holder
Invisible place holder
Invisible place holder
Invisible place holder
Invisible place holder
entranet>
. Press
login
.
. The radio is now ready to accept commands.
command. This displays the currently
RADIO NETADDR=<netaddr>
is 1 to 15 alphanumeric characters (the net-
LED lights to indicate successful connection
prompt (the
.
ENTER
com-
05-4055A01, Rev. E