98
Figure 3-63. DNP3 Routing Menu
•
DNP Routing Enable
function. [
Enabled, Disabled; Disabled
•
DNP Multicast Address
to exchange UDP-encapsulated messages with other IP devices
that are DNP3 aware. This includes PCs, endpoint devices, and
other APs. When a DNP3 packet is received and no routing
information exists for the target device (see
below), the AP sends the packet to all other IP devices
database
in an attempt to find a radio that recognizes the address.
[
Valid IP address; 224.254.1.1
•
DNP Multicast Port
DNP3 Multicast messaging. [
•
DNP Unicast Port
establish a socket to other IP devices. This UDP port (along with
the AP local IP address) is used to encapsulate DNP3 messages
over IP. [
0-65535; 20001
•
DNP3 Routing Database
the current DNP3 routing information known by the AP can be
viewed.
NOTE: For installations that include multiple APs, it is important to
properly configure IAPP, which is located within the Mobility
Menu. IAPP allows APs to share their DNP3 routing
information.
MDS entraNET Technical Manual
—Enables or disables the DNP3 routing
]
—Specifies the group address with which
]
—Specifies the IP port number used for all
0-65535; 20000
—This field specifies the IP port number used to
]
—This selection brings up a screen where
DNP3 routing
]
05-4055A01, Rev. E