Set Key Ap Parameters; Step 4-Configure The Remote Radio; Log-In And Configuration - GE MDS entraNET 900 Technical Manual

Menu Item Management System Loca-
tion
IP Address Main Menu >> Network
Configuration > IP
Configuration
IP Address Main Menu >> Network
Mode Configuration > IP
Configuration
IP Netmask Main Menu >>
Network Configuration > IP
Configuration
Net Address Main Menu >>
Network Configuration >
Wireless MAC Configuration
RF Output Main Menu >>
Power Radio Configuration >
(non-ETSI)
RF Output Main Menu >>
Power (ETSI) Radio Configuration >
Password Main Menu >>
Changes Security Configuration >
User Passwords
* We recommend setting Net Address to the last four digits of the AP serial number to reduce the chance of conflict
with other nearby entraNET systems.
05-4055A01, Rev. E
Table 2-1. Key AP Parameters and Defaults
Default
192.168.1.1
Static
255.255.0.0
9999
900 MHz: 30 dBm
2.4 GHz: 27 dBm
2.4 GHz: 20 dBm
Administrator Password:
admin (lower case)
Guest Password:
guest (lower case)
STEP 4—CONFIGURE THE REMOTE RADIO
The instructions below summarize essential Remote settings for
tabletop testing. For detailed log-in and menu navigation instructions,
see CHAPTER 4 REMOTE RADIO MANAGEMENT, beginning on
Page 99.

Log-in and Configuration

Prepare the Remote for configuration as follows:
1. Connect a PC to the
2. Establish a terminal session (using HyperTerminal, for example)
using the following data parameters:
• 19200 bps
• 8 bits
• no parity
• one stop bit (8N1)
MDS entraNET Technical Manual
Values or Range
Contact your Network
Administrator.
If IP Address Mode (below) is set
to Dynamic, IP Address is
configured automatically.
Static | Dynamic
Settable per customer
requirements
1-15 alphanumeric characters*
900 MHz: 20–30 dBm
2.4 GHz: 17-27 dBm
2.4 GHz: 10-20 dBm
• 1–8 alphanumeric characters
• Passwords are case sensitive;
can be mixed case
port on the radio.
COM1
23