Ipod Mode; Cleaning And Maintenance - Sanyo DMP-P3 Instruction Manual

iPod Universal Dock Adaptor
1. Select the iPod universal dock adaptor (not
included, check your iPod packaging if it came with
this adaptor) that fits with your iPod model.
2. Install the adaptor with the 2 tabs facing the front,
by pushing it down in the universal dock on top of
the unit.
3. To remove the adaptor, press its inside rear surface
and pull it upward.
Note:Make sure you use the correct adaptor for your
iPod to prevent damage due to insecure iPod seating.
Listen to iPod
1. With the correct iPod universal dock adaptor installed, gently dock the iPod into
the unit's universal dock.
2. Depending upon your iPod, the iPod battery will begin to charge when docked-
PLEASE REFER TO iPOD COMPATIBILITY CHART ON PAGE 11. For charging
period, follow your iPod's instruction manual.
3. Slide the FUNCTION switch to ON position and slide the MODE switch to iPOD
mode.
4. Control the iPod to playback music as mentioned in the iPod's instruction manual
Note:This unit display cannot display any music information from your iPod. Please
view the music information through your iPod display.
Charging your iPod while in AM radio mode is not recommended as it can interfere
with the AM reception.
1. If the cabinet becomes dusty, wipe it with a soft cloth.
2. If the cabinet becomes smudged or dirty, clean it with a soft, slightly dampened
cloth.
3. Never allow water or any liquid to get inside the cabinet.
4. Never use any abrasive cleaners or cleaning pads as these will damage the finish
of your unit.

iPod MODE

CLEANING AND MAINTENANCE

-9-