General Functions - Sanyo DMP-P3 Instruction Manual

Switching On and Off
1. The unit will automatically switch to standby mode once the AC power source is
connected.
2. Switch on the device from standby mode by sliding the FUNCTION switch to ON
position.
3. Switch the device to standby mode by sliding the FUNCTION switch to OFF
position.
4. The display will show the time once the AC power source is connected.
Selecting Play Mode
1. Switch the unit on by sliding the FUNCTION switch to ON position.
2. Select the play mode by sliding the MODE switch to either AM / FM / iPod.
Adjusting the Volume
The volume can be adjusted by rotating the VOLUME knob located at the side of
the unit.
Setting Clock
1. Press and hold the TIME button and press the HOUR button to set the hour and
press the MIN button to set the minute.
2. Release the buttons to confirm settings.
Setting Alarm
1. Press and hold ALARM button on the unit and press the HOUR button to set the
hour and press the MIN button to set the minute.
2. Release the buttons to confirm settings.
3. Slide the FUNCTION switch to AUTO / BUZZ to set the alarm.
4. Select AUTO mode to wake up by radio and select BUZZ mode to wake up by
buzzer.
5. The ALARM LED will illuminate on the display once the alarm is set.
6. Slide the MODE button to select the wake-up mode.
7. When the alarm time is reached, depending upon your prior selection, the AM
radio or FM or the buzzer will sound.
8. If the iPod is selected as the wake-up mode, the buzzer will sound.
9. Press ALARM button to cancel the alarm and the ALARM LED will remain on the
display and the alarm will sound again on the next day at the same time.
10.Slide the FUNCTION switch to ON / OFF to cancel the alarm.
Snooze Function
Press SNOOZE button to silence the ALARM sound (radio / buzzer) temporarily for
approximately 9 minutes. The snooze function is repeatable for 119 minutes and will
automatically stop, however the alarm remains set and activates again according to
your alarm mode settings.

GENERAL FUNCTIONS

-7-