Information; Specifications - Sanyo DMP-P3 Instruction Manual

Troubleshooting
If a fault occurs, first refer to this information before you take the device for repair.
If you are unable to rectify the fault using the information given here, contact
Customer Support for advice.
Under no circumstances should you attempt to repair the device yourself, as this
would invalidate the warranty.
PROBLEM
No Sound
The device does not
respond to button
commands
Poor radio reception Weak radio signal
Power:
AM :
FM:
DC Backup :
Unit output power:
Power Consumption : 13W
Measurement:
Weight:

INFORMATION

POSSIBLE CAUSE
Volume is too low.
Power cord incorrectly
connected.
Electrical static discharge. Switch off the
Interference from
electrical devices such as
televisions,video recorders,
computers,neon lamps,etc.

SPECIFICATIONS

AC 240 V ~ 50 Hz
530 - 1600 kHz
88 - 108 MHz
9V (6F22 9Vx1)
1 x 0.5 W
160(L) X 125(W) X 69(H)mm
0.67 KG
-10-
REMEDY
Increase volume
Connect power cord correctly.
device,disconnect the mains
cable and plug it in again after
a few seconds.
FM: Extend the FM antenna to
its full length or try to change
the postion and direction of
the FM antenna.
AM: Change the position of
the unit until it picks up the
strongest signal.
Move the unit away
from the other operating
electrical equipments such
as motorized appliances,
televisions, and microwave
ovens.