Sanyo DMP-P3 Instruction Manual page 6

Power Source
This product is designed to operate on normal 240V~50Hz AC power only. Do not
attempt to operate the unit on any other power source. You could cause damage to
the product that is not covered by your warranty.
AC Power Supply Connection
1. Check the rating label located at the bottom of the unit corresponds to your local
mains supply.
2. Make sure the wall socket is switched off, then plug the AC plug into the wall
socket.
3. Switch on the wall socket.
CAUTION:
The device is connected to the mains with the AC plug. Disconnect the AC plug
from the wall socket if you want to completely disconnect the device from the
mains. Make sure the power plug is easily accessible during operation and not
hindered by other objects.
DC Backup Battery
Install Battery
1. Open the battery compartment door.
2. Install 1 x 9V/6F22/006P/PP3 type battery (not
included) into the back up battery compartment
located at the bottom of the unit (Alkaline batteries
are recommended for longer life time).
3. Be sure to observe the polarity markings, and then
close the battery compartment cover.
4. In the event of AC Power cut off, the backup battery
maintains the time settings.
Battery Precautions
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated
in the battery compartment. Reversed batteries may cause damage to the
device.
3. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture.(Follow battery manufacturer's directions.)
5. Do not disassembly it.Do not dispose of the old battery in a fire.
-4-