Rear View - Mitsubishi Electric HS-MD3000E Installation And Operation Manual

Rear View

AUDIO
IN
AUDIO
OUT
MONITOR
RESET
Warning:
The included power cord is used for 220 - 230 V, 50 Hz.
Do not connect to any outlet or power supply having a different voltage or frequency.
Ensure the power cord is not plugged into the outlet before connecting to any rear terminals.
Note
AUDIO IN (CH-1/L) connector
CH-1/L audio input connector (RCA jack).
AUDIO IN (CH-2/R) connector
CH-2/R audio input connector (RCA jack).
75ohm termination switch for VIDEO IN LOOP THROUGH
connector
Switch it to OFF when the monitor is connected to VIDEO IN
LOOP THROUGH connector. Switch it to ON when no
equipment is connected to VIDEO IN LOOP THROUGH
connector.
VIDEO IN LOOP THROUGH connector
The signal from the VIDEO IN connector is looped out to this
connector.
75ohm termination switch for S-VIDEO IN LOOP THROUGH
connector
Switch it to OFF when the monitor is connected to S-VIDEO
IN LOOP THROUGH connector. Switch it to ON when no
equipment is connected to S-VIDEO IN LOOP THROUGH
connector.
S-VIDEO IN LOOP THROUGH connector
The signal from the S-VIDEO IN connector is looped out to
this connector.
AUDIO OUT (CH-1/L) connector
CH-1/L audio output connector (RCA jack).
AUDIO OUT (CH-2/R) connector
CH-2/R audio output connector (RCA jack).
MONITOR connector
Monitor audio output connector (RCA jack). The audio signal
selected by MONITOR switch on the front panel is output from
this connector.
Reference page
VIDEO S-VIDEO
CH1 75ohm 75ohm
OFF ON OFF ON
L
CH2
R
LOOP
THROUGH
CH1
L
IN
CH2
R
OUT
FOOT
REMOTE
SW
Symbol " ": equipotentiality
Symbol " ": alternating current
RESET button
page 19
VIDEO IN connector
Input connector for video signal (BNC connector).
VIDEO OUT connector
Output connector for video signal (BNC connector).
FOOT SW jack
The foot switch which is used to control recording is connected
to here. The foot switch shall comply with any of the following
standards UL544, UL187, UL2601-1, CSA125, CSA114 or
CSA601-1.
S-VIDEO OUT connector
Output connector for video signal (S-VIDEO connector).
REMOTE jack
Remote control is possible by connecting the remote control
unit (R-3001) here.
S-VIDEO IN connector
Input connector for video signal (S-VIDEO connector).
Battery Box and RS-232C/34-pin options
Battery is stored here. Also install optional RS-232C/34-pin
interface board to here.
Note
• This VCR contains a special battery. Consult your dealer to
replace it.
AC power socket
This socket connects to the power cord. Insert the cord firmly.
Potential equalization connector
This is used to equalize the potential of the equipment
connected to the unit. For details, refer to the installation
instruction of the equipment to be connected.
Introduction
5