Fujitsu Eternus DX80 S2 User Manual page 71

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
4-2
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
The M5 screw positions for the rack rails are determined relative to the drive enclosure
base line.
Insert the M5 screws in the 1st and 6th holes on the front rack rails above the base line
and in the 2nd and 5th holes on the rear rack rails above the base line as shown in the
figure below:
Front of drive enclosure
[Left]
6th position
(M5 screw)
2U
1st position
(M5 screw)
Base line of
drive enclosure
Rear of drive enclosure
[Left]
5th position
(M5 screw)
2U
2nd position
(M5 screw)
Base line of
drive enclosure
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Install the drive enclosure in the rack.
CAUTION
Copyright 2012 FUJITSU LIMITED
[Right]
6th position
(M5 screw)
1st position
(M5 screw)
Rack rails
[Right]
5th position
(M5 screw)
2nd position
(M5 screw)
Rack rails
Do
• When installing or removing the drive enclosure to or from
the rack, make sure that the sides and the bottom of the
drive enclosure are held by two or more people. Failure to
do so may cause injury.
71
Step (1).
P3AM-4842-03ENZ0