Additional Drive Installation Procedure - Fujitsu Eternus DX80 S2 User Manual

Chapter 5 Installing Optional Products
5.1 Installing Drives
5.1.4

Additional Drive Installation Procedure

This section describes how to install additional drives in the ETERNUS DX Disk storage system.
■
For 2.5" drives
Procedure
1
2
3
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Do
CAUTION
• If additional drives are installed in a way other as described herein,
damage and/or device failure or electrical shock may occur.
Do Not
• Do not install drives that are for use in other devices.
In the [Storage] screen of [Component] on the ETERNUS Web GUI screen,
check that all components of the ETERNUS DX Disk storage system are in
normal status.
Wear a wrist strap or touch a metal part to discharge the human body's natural
static electricity.
Remove the dummy drive unit from the slot in which the drive is to be installed.
Push into the tab of the dummy drive unit and pull it straight out of the drive slot.
Dummy drive unit
Tab
The removed dummy drive unit should be retained for future use.
IMPORTANT
Copyright 2012 FUJITSU LIMITED
61
P3AM-4842-03ENZ0