Fujitsu Eternus DX80 S2 User Manual page 38

Chapter 2 Basic Operation
2.1 Powering On and Off
The procedure below explains how to turn off the power via the Power switch.
For details on how to turn off the power via ETERNUS Web GUI or ETERNUS CLI, refer to
"ETERNUS Web GUI User's Guide" or "ETERNUS CLI User's Guide".
Procedure
1
2
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Press and hold the Power switch of the controller enclosure for four seconds or
more.
Power switch
The READY LED of the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed
IMPORTANT
again between the time of the READY LED turning off and the
POWER LED turning off, the ETERNUS DX Disk storage system
power may turn on.
The ETERNUS DX Disk storage system power is turned off.
The POWER LEDs on the controller enclosure and the drive enclosures are turned off.
Copyright 2012 FUJITSU LIMITED
Drive enclosure
Drive enclosure
Controller enclosure
38
End of procedure
P3AM-4842-03ENZ0