Revert Channel - Kenwood ProTalk TK-3201 Instruction Manual

■ Temporary Delete
You can temporarily remove specific channels from the
scanning sequence during Scan. When Scan pauses at a
channel, you can remove that channel from the scanning
sequence by pressing and holding the key programmed
as Temporary Delete for 1 second or Scan + Temporary
Delete for 3 seconds.
• You cannot remove a channel if there will be less than
2 channels available for scanning remaining.
• To add the removed channels back into the Scan list, simply
exit Scan mode or switch the transceiver power OFF and then
ON again.

■ Revert Channel

During Scan, pressing the PTT switch will automatically
select the transceiver's Revert channel and you will begin
transmitting. Your dealer can program the Revert channel
using one of the following methods:
• Selected: The last channel selected prior to scanning is
assigned as the Revert channel.
• Selected + Talkback: The last channel selected prior to
scanning is assigned as the Revert channel. However, the
transceiver also transmits on the channel where Scan is
currently paused. This is the default Revert channel setting.
• Priority: If your dealer has programmed a Priority channel,
it is the Revert channel.
• Priority + Talkback: If your dealer has programmed a
Priority channel, it is the Revert channel. However, the
transceiver also transmits on the channel where Scan is
currently paused.
32