Simplified Remote Control; Setting The Controlling Zone Of The Simplified Remote Control; Replacing The Battery In The Simplified Remote Control - Yamaha DSP-Z11 Owner's Manual

Remote control features

Simplified remote control

Use the supplied simplified remote control to make basic controls of this unit.
STANDBY
Sets the selected zone to the
standby mode.
SYSTEM MEMORY
Save or recall the system settings.
PRESET +/–
Recall the preset network/USB
contents.
s(stop) / p(play) /
b(skip backward) /
a(skip forward)
Control playback of the iPod or
Network/USB contents.
☞ P. 64, 67
Note
When you select "NET/USB" as the input source, this unit activates the last selected sub input source (see page 67).
■ Setting the controlling zone of the simplified
remote control
Use this feature to set the controlling zone (see page 116) and
remote control ID (see page 119) of the simplified remote control.
Setting the remote control ID
Press and hold b on the simplified remote control and then 1 or
2 for 3 seconds to select the desired remote control ID.
• ID1: Press and hold b and 1.
• ID2: Press and hold b and 2.
Setting the controlling zone
Press and hold a on the simplified remote control and then 1, 2,
3, or 4 to select the desired zone.
• Main zone: Press and hold a and then press 1.
• Zone 2: Press and hold a and 2.
• Zone 3: Press and hold a and 3.
• Zone 4: Press and hold a and 4.
110
En
STANDBY
☞ P. 39
☞ P. 96
☞ P. 70
POWER
SYSTEM MEMORY
1 2 3 4
INPUT
INT SOURCE VOLUME
PRESET
MUTE
Remove the insulation sheet before using the remote
control.
■ Replacing the battery in the simplified remote
control
Change the battery when the operation range of the simplified
remote control decreases.
Use a straight
pin to remove
the cover.
Notes
• Insert the battery according to the polarity markings (+ and –).
• If the batteries run out, immediately remove them from the simplified
remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful not to let
the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
POWER
Turn on the power.
INPUTl / h
Select the input source.
VOLUME +/–
Adjust the volume level.
MUTE
Mutes the audio output.
Replace the battery Close the cover.
with a new CR2025
battery.
☞ P. 39
☞ P. 50
☞ P. 50
☞ P. 52