Using The Remote Control; Opening And Closing The Front Panel Door; Voltage Selector (Asia And General Models Only) - Yamaha DSP-Z11 Owner's Manual

Getting started

Using the remote control

The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote control
sensor on this unit during operation.
Remote control sensor
MAIN ZONE
ON
ON/OFF OFF
INPUT
Approximately
30
6 m (20 ft)
6LIGHT
Lights up the remote control buttons and the display window (4).
Display window (4)
ID 1
MAIN
ZONE 2
ZONE 3
ZONE 4
[3]
[1] ID1/ID2 indicator
Indicates the currently selected remote control ID (see
page 119).
[2] Transmit indicator
Appears while the remote control is sending infrared signals.
[3] Zone indicators
Indicates the currently controlling zone (see page 116).
[4] Information display
Shows the name of the selected input source that you can
control.
Infrared window (1)
Outputs infrared control signals. Aim this window at the component
you want to operate.
Operation mode selector (F)
The function of some buttons depends on the operation mode
selector position.
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input selector button
(see page 103).
TV
Operates the TV (see page 102).
12
En
MASTER PURE DIRECT
STRAIGHT TUNING MODE MEMORY FM/AM PRESET/TUNING PROGRAM MENU VOLUME
EDIT
SPEAKERS
AUDIO SELECT A B EFFECT DISPLAY MAN'L/AUTO CATEGORY SEARCH MODE
ZONE REC OUT/
ZONE ON/OFF CONTROLS ZONE 2 TONE CONTROL
MULTI
ZONE
ZONE 2 ZONE 3 ZONE 4 PUSH ENTER
SILENT CINEMA YPAO S VIDEO VIDEO L AUDIO R OPTICAL
OPTIMIZER
PHONES MIC VIDEO AUX HDMI IN USB
30
[1] [2]
ID 2
[4]
Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types of
conditions:
– places of high humidity, such as near a bath
– places of high temperatures, such as near a heater or stove
– places of extremely low temperatures
– dusty places
Backlight mode
The remote control is equipped with the motion sensor and the
remote control lights up the backlight corresponding to the
motions or operation. If you do not want to lights up the
backlight when this unit detects motions, change the backlight
mode (see page 104).

Opening and closing the front panel door

When you want to use the controls behind the front panel door, open
the door by gently pressing on the lower part of the panel. Keep the
door closed when not using these controls.
To open, press gently on the lower part of the panel.
VOLTAGE SELECTOR
(Asia and General models only)
Caution
The VOLTAGE SELECTOR on the rear panel of this unit must
be set for your local voltage BEFORE plugging the power cable
into the AC wall outlet. Improper setting of the VOLTAGE
SELECTOR may cause damage to this unit and create a
potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or counterclockwise
to the correct position using a straight slot screwdriver.
Voltages are as follows:
...................... AC 110/120/220/230–240 V, 50/60 Hz
VOLTAGE
SELECTOR
230-
240V
Voltage indication