9
Secure the top and bottom portions of the network board with
the two screws supplied with the network board.
10
Connect the LAN cable to the network board.
11
Connect the power cord to the printer.
12
Plug the power plug into the AC power outlet.
13
Connect the USB cable to the printer as needed.
Resetting the Network Board
If you want to reset the network board to the default values, use any one of the
following methods. For details, see "Network Guide".
Remote UI
•
FTP Client
•
NetSpot Device Installer
•
Even if none of the above methods work, you can reset the settings for the network
board by setting the DIP switches using the following procedure.
NOTE
A Phillips screwdriver is required for removing or installing the network board. Have a
screwdriver ready in advance that matches the size of the screws.
Network Board
9-27
9