Cancel / Abort Feature (Optional); Bypassing Zones; Group Bypass; Unbypassing - GE NX-108E - Security NetworX NX-4 System User Manual

CANCEL / ABORT feature (optional)

The cancel light will flash during an abort delay time. If a code is entered followed by the [CANCEL] key while this
light is flashing, all abortable reports will stop the communication process. NOTE: The abort feature must be
enabled. Entering a code followed by the [CANCEL] key during or after an alarm report to the central station will
cause the cancel light to come on. It will stay on until the central station has received the cancel report. NOTE: The
cancel feature must be enabled.

Bypassing zones

If you wish to bypass one or more zones, this must be done while the system is in the disarmed state. The
following steps are used for bypassing zones:
Step 1 Press the [BYPASS] key.
Step 2 Enter user code, if required (optional). The bypass light flashes.
Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass. (Example: Press the [1] key for zone 1, press [1] -
[2] for zone 12.)
Step 4 Press the [BYPASS] key again.
Step 5 The corresponding zone light will illuminate indicating the zone has been bypassed. Repeat steps 3 and 4
for any other zone(s) that need to be bypassed.
Step 6 Press the [BYPASS] key again -or- press the [#] key to exit the Bypass Mode. The bypass light will stop
flashing upon exiting the Bypass Mode.

Group bypass

By pressing the [BYPASS] key, followed by the [0] [0] key, then the [BYPASS] key again, all zones that are designated
as group bypass zones will be bypassed. Press the [BYPASS] key again to exit group bypassing.

Unbypassing

To manually unbypass zones, perform the bypassing procedure on a zone that is already bypassed. The
corresponding light for that zone will go off when unbypassed.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.

Turning the door chime ON and OFF

The door chime feature must be enabled by your installer. The door chime is turned on or off by pressing the
[CHIME] key. If the chime is on, the chime light will be illuminated. If the chime is off, the chime light will be off.
Each press of the [CHIME] key will toggle the chime feature on/off and produce a momentary ding-dong sound.
NX-108/116/124E User manual Page 11 10/11/05