Changing Modes While System Armed; Disarming The System; Cancel / Abort Feature (Optional) - GE NX-148E User Manual

Changing modes while system armed

Step 1 Pressing the [STAY] key will turn on/off (toggle) a delay on Entry/Exit doors and turn on/off
(toggle) the "INSTANT" message.
Step 2 (Optional, only possible if "bypass toggle option" has been programmed by
your installer)
Press the [BYPASS] key at this time to turn on/off (toggle) all designated interior zones.
Step 3 (Optional, only possible if "re-exit option" has been programmed by
your installer)
When armed, pressing the [EXIT] key will start the Exit delay, enabling you to leave the
building.
The instant light needs to be off at this time if you plan on re-entering the building, otherwise you will create an
alarm. You may re-initiate an entry/exit delay by pressing the [STAY] key again. The instant light will go out.

Disarming the system

When you enter the protected area through one of the designated Entry/Exit doors, the keypad control will
sound a continuous tone for the duration of the entry delay time, or until you
enter a valid code.
• Enter a valid user code.
• The red armed light will go off and the tone will stop. The
security system is now DISARMED. If a valid code is not entered before the end of the
entry delay, an alarm will occur.
NOTE: If the red armed light is flashing during the entry delay, the alarm system has been activated in
your absence. Leave the building immediately and call your alarm company and/or the police from a
safe location.

CANCEL / ABORT feature (optional)

The cancel light will flash during an abort delay time. If a code is entered followed by the [CANCEL] key while
this light is flashing, all abortable reports will stop the communication process. NOTE: The abort feature
must be enabled. Entering a code followed by the [CANCEL] key during or after an alarm report to the
central station will cause the cancel light to come on. It will stay on until the central station has received the
cancel report. NOTE: The cancel feature must be enabled.
NX-148E User manual
IMPORTANT!
Page 10
g
GE Security
Type code to
Disarm
04/10/04