Screen Control Command; Cf_Screen Command; Cf_Overscan Command; Cf_Dzoom Command - Sanyo PDG-DSU30 - 2500 Specifications

PDG-DSU30 Expand Serial Command Functional Specifications

8.7 Screen Control Command

8.7.1

CF_SCREEN Command

Command "CF_SCREEN_%1" [CR]
"NORMAL" ----------- Select 4:3 screen display
"WIDE1" -------------- Select 16:9-i screen display
"WIDE2" -------------- Select 16:9-ii screen display
"TRUE" ---------------- Select native screen display
%1 "AUTO" --------------- Select Auto
"UP" -------------------- Switch screen upward
"DN" -------------------- Switch screen downward
Select Aspect ratio. (Valid only when in the normal Power ON status.)
Details
The projector shows indication display when receiving the command.
Acceptable
Correspondence
Unacceptable
8.7.2

CF_OVERSCAN Command

Command "CF_OVERSCAN _%1" [CR]
%1 "000~003" -------- Directly specify the value of Overscan
Set the value of Overscan.(Valid only when in the normal Power ON status.)
Details
The projector shows NO indication display when receiving the command.
Acceptable
Correspondence
Unacceptable
8.7.3

CF_DZOOM Command

Command "CF_DZOOM _%1" [CR]
%1 "-05~025" -------- Directly specify the value of D.zoom
Details Set the value of D.zoom.(Valid only when in the normal Power ON status.)
Acceptable
Correspondence
Unacceptable
8.7.4

CF_KEYSTONE Command

Command "CF_KEYSTONE _%1" [CR]
"UP" ------------------ Correct Keystone distortion to resize upper part of image
"FUP" ---------------- Correct Keystone distortion to resize upper part by 2steps
%1 "DN" ------------------ Correct Keystone distortion to resize lower part of image
"FDN" ---------------- Correct Keystone distortion to resize lower part by 2steps
"RST" ---------------- Reset keystone adjust
Change the correction level of Keystone distortion. (Valid only when in the
normal Power ON status.)
The behavior is the same as the "Keystone +/-" button of the remote control.
When the value reaches the correction limit, the projector accepts the
command but does not execute it. Neither it works when exceeding its limit
Details of correction such as;
Projector returns the error code"201" in those cases above.
Acceptable
Correspondence
Unacceptable
* Normal - Wide1 - Wide2- True - Auto
* Auto - True - Wide2 - Wide1 - Normal
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
1) in case of receiving the command "Right" when right side of the
image have already reached its correction limit.
2) in case of receiving the command "FUP" when it is 1 step to the
correction limit.
"000" [CR]
"Error Code" [CR]
20 / 42