Canon VB-C300 Administrator's Manual page 99

Connect to Camera
1. Enter the Host Name or IP address in [Host Name or IP], then enter the port number for the Camera Server
in [Port].
The [Host Name or IP] should be 255 characters or less (each label, separated by a period, must be 63
characters or less), the IP address must be 15 characters or less (each label, separated by a period, must
be 3 characters or less), and the [Port] must be a figure within the range from 1 to 65535.
2. Enter the user name and password to connect to the Camera Server. Enter the user name in [User Name]
and password in [Password].
The settings are then saved to the Storage Server.
Note
Use the user name and password configured on the Camera Server. If the user name and password are
not sure, ask for the System Administrator of the Camera Server.
Storage servers and VK Viewers do not support IPv6.
3. Click [Connect].
Once the Viewer has connected with the Camera Server, a tab is shown next to the [Add Camera Server]
dialog.
Note
You must click [Connect] before clicking [OK] to close the dialog (the [OK] button is disabled until you do
so).
When two or more cameras are used with VB150 (when [Video Input] is set to [Multiple]), two through four
tabs are added. The number of tabs shown for a VB150 does not indicate the physical number of
cameras connected, but indicates the number of cameras which have been enabled using the VB150
[Camera and Video Settings] Page. Please see Chapter 3, P. 36 of the VB150 User's Manual for more
details.
If [Video Input] is set to [Single] for VB150, the camera name displayed as the Camera Server Name is
the first camera name in the server's camera name list when [Use Camera] is selected on the [Camera
and Video Settings] Page. Therefore, it is recommended that the Administrator should set the first camera
name to be a general name, applicable to the entire Camera Server.
If you are using a VB150 with the [Settings Web page URL] other than the default setting "admin", a
connection error occurs when you click [Connect]. Restore the default setting and try again.
Tip
If you have a Multi-Terminal Module VB-EX50 unit plugged into a VB-C50i/VB-C50iR, VB-C50FSi, VB-C50Fi
and have configured the [Use External Video Input], video seen in the Viewer may be taken from cameras
connected to the Multi-Terminal Module. Switch the video at the Admin Viewer as required.
Register Camera Server
4-19