Canon VB-C300 Administrator's Manual page 277

Event type
Connection error to the camera server
Continuing recording
Changing the recording frame rate
Error Number: Error Description
10048: Address in use
10050: Network down
10051: Network unreachable
10054: Forced disconnection from
camera
10060: Connection timeout
10061: Camera connection refused
10064: Camera power off
10065: Camera unreachable
10091: Network board not ready
11001: Host not found
11004: Host not found
Empty character string
HT401: Authentication required
HT403: Host/IP address restricted
HT502: Bad Gateway 502
HT503: Service unavailable 503
HT504: Gateway Timeout 504
Displayed Messages
Error (on)/ok (off)
Connection to host <camera server address> : <port> <status>
Recording continuing
Effective recording rate (<recording rate before change>
<recording rate after change> %)
Recording rate is the ratio of received images that are actually
being recorded. If the rate is 100%, then all received images are
recorded. If 50%, 1 frame per 2 frames is recorded.
A socket for the communication could not be generated because
a large number of TCP connections are used in the PC.
The network is down (when a failure occurs in a HUB or router
located near the PC).
A failure occurred in a HUB or router near the camera server.
The TCP connection is disconnected because the camera server
was restarted or another cause.
A timeout occurred in the TCP connection with the camera server
(This occurs when the camera server is down).
The camera server rejected the TCP connection (This occurs
when the port number specification is incorrect or another
cause).
The camera server is down (Normally, 10060 occurs).
There are no routes to connect to the camera server (This may
also occur when there is a failure in the network cable connected
to the PC or HUB).
There is a failure on the PC network board.
The host name in DNS could not be resolved.
The host name in DNS could not be resolved (11004 may occur
instead of 11001 in 2003).
Other Winsock Errors
The user authentication or password for connecting to the
camera server is incorrect. Check to ensure that it is not an on/off
event.
Cannot connect due to the IP address restriction on the camera
server side.
The proxy server returns an HTTP 502 error (which occurs when
the proxy server receives an error from the upper proxy).
The proxy server returned an HTTP 503 error (which occurs when
the proxy server failed to connect to the camera server).
The proxy server returned an HTTP 504 error (which occurs when
the proxy server could not receive a reply from the upper proxy).
Cause
Messages List
9-35