Remove The Battery Pack; Remove The Solid-State Drive (Ssd) Module - Lenovo 20V9003DIX Hardware Maintenance Manual

Remove the battery pack

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Release the speaker cable from the cable guide and remove five screws. Then, remove the battery
pack.
Figure 52. Remove five screws and remove the battery pack
Screw specifications
M2 x L3
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Peel off the tape and then remove one screw.
Number of screws
5
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
59