Table of Contents
Advertisement
Figure 34. Peel off the pieces of tape
Step 3.
Detach the antenna cable connectors. Then, disconnect the trans board cable and the EDP cable
from the system board.
Figure 35. Detach the antenna cable connectors, disconnect the trans board cable and the EDP cable from the
system board
Step 4.
Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove six screws and then remove the LCD unit.
.
Chapter 4
Removing a FRU or CRU
49
Advertisement
Table of Contents
