Table of Contents
Advertisement
position. Do not run a warm engine with choke in the
ON position.
1. Choke
2. Throttle
3. Rear reference bar
4. Left motion-control lever
5. Message display
Throttle Control
Located on the left side of the control console
6).
The throttle is used to control the engine speed.
Moving the throttle lever forward will increase the
engine speed and moving the throttle lever to the rear
will decrease the engine speed. Moving the throttle
forward into the detent is full throttle.
Parking-Brake Lever
Located on the right side of the machine.
The brake lever engages a parking brake on the drive
wheels.
Note:
The LCD indicator appears in the message
display on the front console when the park brake is
engaged
(Figure 6
and
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the
brake.
When parking on a steep slope, the wheels must be
chocked or blocked in addition to the brake being
engaged. The machine must be tied down and brake
engaged when transporting.
The parking-brake must be disengaged before moving
motion control out of neutral or the engine must begin
shutdown.
Figure 6
6. Front reference/speed
control bar
7. Right motion-control lever
8. PTO switch
9. Ignition
Figure
8).
Ignition Switch
Located on the right side of the control console
6).
The ignition switch is used to start and stop the
engine. The switch has three positions OFF, ON, and
START. Insert the key into switch and rotate clockwise
to the ON position. Rotate clockwise to the next
position to engage the starter (the key must be held
against the spring pressure in this position). Allow the
key to return to the ON position immediately after the
engine starts.
g446526
1. Off
2. On
(Figure
Note:
To start the engine, place the motion control
levers in neutral and disengage the PTO switch (it is
not necessary for the operator to be on the platform).
Hour Meter
Located in the center of the front control console in
the message display
The hour meter records the number of hours that the
engine has run.
1. LCD indicators
2. Low voltage indicator light
The hour meter is recording when the decimal point is
flashing in the hour/voltage display.
11
Figure 7
3. Start
(Figure
8)
Figure 8
3. Hour/voltage display
(Figure
g219837
g275343
Advertisement
Table of Contents
