Table of Contents
Advertisement
Figure 33
1. Chain
2. Leveling adjust locking nuts
13.
Raise the deck and remove the blocks. Lower
the deck back to 7.6 cm (3 inches) and recheck
the cutting height.
14.
Raise the deck into the transport position and
reinstall the deck lift assist spring. Tighten the
adjuster screw until a 6.0 to 6.4 cm (2-3/8 to
2-1/2 inches) gap is present
Note:
If the front to rear blade tip height
difference is good, but the height is off, additional
adjustments can be made using the lift rod.
15.
Loosen both of the jam nuts on the lift rod and
rotate the rod to raise or lower the deck. Tighten
the jam nuts when desired position is achieved
(Figure
34).
g313831
(Figure
33).
40
Figure 34
1. Deck lift rod
g313832
2. Jam nut
Advertisement
Table of Contents
