3. SPECIFICATIONS
MELSEC-A
*I:
The unit of the transmission (sendlreceive) data in the no-protocol mode or bidirectional
mode
or
of the send data when the on-demand function of the dedicated protocol is used.
'2: Set this when the RS-232C interface is set to half-duplex communications.
*3: Areas should be allocated so that they do not overlap with each other when (a) data is
transmitted in the no-protocol mode or bidirectional mode, or (b) when more than one
function of data transmission using the on-demand function of the dedicated protocol is
used.
'4:
Change the defaultvalues marked by the dot symbol
( 0 )
attached t o the right of the address
only when the READY signal of the AJ7t C24 is turned ON after the power is turned ON
or
the PC CPU is reset