Mitsubishi Electric AJ71C24-S6 User Manual page 118

7. INITIAL SETTING OF TRANSMISSION CONTROL DATA TO
BUFFER MEMORY
M C l C C P A
a w l
LLGLu-m
Setting method
(1)
Setting the bidirectional mode with the following conditions (AJ71C24
1 1 0
addresses: 80 t o 9F)
1)
Set the bidirectional mode.
2) Set the time-out check time t o 2 seconds. The setting value is 2 C
(14H).
3) Set the send data t o "invalid" and the received data t o "valid" f o ~
simultaneous transmission.
4)
Set the check sum t o "disable"
(Sequence Program)
Write '1" to buffer memory address 112H.
Write H14 to buffer memory address 113H.
Write H l 0 0 t o buffer memory address 114H.
Write " 1 ' to buffer memory address 115H.
(2) Setting the bidirectional mode with the following conditions (AJ71C24
I10 addresses: 11
0
to 12F)
1) Set the bidirectional mode.
2) Set the time-out check time to "infinite".
3)
Set the send data to "valid" and the received data to "valid" foi
simultaneous transmission.
4)
Set the check sum to "enable".
(Sequence Program)
H m
HI12
I
K1
[
K1 Write "1" to buffer memory address 112H.
Leave settings of buffer memory addresses
113H for 115H for defaults.