Husqvarna DXR 95 Operator's Manual page 83

To operate the outriggers
1. Push the operation mode switch (A) down to select
transport mode.
B
1
C
3
A
2. Do the procedure that follows for one lever control:
a) Turn the transport mode switch to one lever
control (B).
b) Use the joysticks to extend and retract the
outriggers. Refer to
"Pattern 2" on page 57 and "Pattern 3" on page
60 .
3. Do the procedure that follows for two lever control:
a) Turn the transport mode switch to two lever
control (C).
b) Use the joysticks to extend and retract the
outriggers. Refer to
To stop the product (DXR 95)
1. Park the product on level ground.
2. Retract the arm system until the arm system is on
the ground and the tool fully sits on the surface.
1401 - 005 - 11.01.2024
"Pattern 1" on page 52 ,
"Pattern 1" on page 52 .
3. Release the joysticks (A) on the remote control into
the neutral position.
A
B
4. Turn the OFF/ON/START switch (B) to the OFF
position.
5. Disconnect the power plug.
To stop the product (DXR 145)
1. Retract the arm system until the arm system is on
the ground and the tool fully sits on the surface.
2. Release the joysticks (A) on the remote control into
the neutral position.
A
B
3. Turn the OFF/ON/START switch (B) to the OFF
position.
4. Step into the work area and open the right hatch on
the product.
A
A
83