Husqvarna DXR 95 Operator's Manual page 107

3. If the breaker grease pump is empty, do the
procedure that follows.
a) Clean the area around the breaker grease pump.
This prevents contamination of the breaker
grease pump system.
b) Attach a grease gun to the grease nipple. Refer
Lubricants on page 147 for the correct type of
to
grease.
A
CAUTION:
nipples in the inspection slot. Make
sure that you attach the grease hose
to the correct grease nipple (A).
c) Fill the breaker grease pump.
d) If you fill too much grease in the breaker grease
pump, grease comes from the hole (B).
1401 - 005 - 11.01.2024
There are 2 grease
B
e) Bleed the breaker grease pump if no grease
comes after you refill the breaker grease pump.
Refer to
(DXR 95) on page 108 .
To do a check of the quantity of grease
in the grease cartridge in the breaker
grease pump (DXR 145)
1. Park the product on level ground and stop the
product. Refer to
page 83 .
2. Examine the quantity of grease in the grease
A
cartridge. The grease cartridge is empty when the
plastic sleeve is at the end stop
.
3. If the grease cartridge is empty, do the procedure
that follows.
a) Clean the area around the grease cartridge
and the breaker grease pump. This prevents
contamination of the breaker grease pump
system.
b) Remove the grease cartridge from the breaker
grease pump.
To bleed the breaker grease pump
To stop the product (DXR 145) on
107