Husqvarna DXR 95 Operator's Manual page 77

2. Push the left side button (A) and the right side button
(B) at the same time.
C
Information center
A
Note:
The Information center display change
mode if the buttons are pushed at the same time.
3. Push the left side button (A) to go to selection "2" in
the information center display.
4. Push the right side button (B) to select selection
"2". The symbol (C) shows in the information center
display.
5. Push and hold the left and right side button at the
same time for 3 seconds.
6. Remove the right side cover on the product.
7. Start the product. Refer to
145) on page 71 .
1401 - 005 - 11.01.2024
B
To start the product (DXR
8. Put a magnet on the bottom side of the radio
communication receiver on the magnet symbol (D)
in 5s after the start of the product. The indicator (E)
on the radio communication receiver flashes orange
quickly when it waits for a pairing operation to start.
D
E
Note:
It is necessary to put the magnet on the
magnet symbol in 5s after the start of the product.
After 5s the radio communication receiver cannot do
the pairing operation.
9. Remove the magnet immediately.
10. A serial number shows on the information center
display when a radio communication receiver is
found.
11. Make sure that the serial number on the information
display agrees with the serial number on the radio
communicator receiver.
12. If the serial numbers do not agree, the pairing
operation was not done correctly. Do the procedure
that follows.
a) Find the product with the agreed serial number
and turn that product off.
b) Stop your product. Refer to
(DXR 145) on page 83 .
c) Do the pairing operation again.
13. Push the right side button when the serial numbers
agree. A message on the information center display
will show for 2 seconds that the pairing operation is
done.
14. Stop the product to restart the radio communication
receiver. Refer to To stop the product (DXR 145) on
page 83 .
To stop the product
77