Husqvarna DXR 95 Operator's Manual page 69

Radio signal
No radio signal.
• Battery status (B). The same symbols are also
shown in the top bar on the display. Refer to
Symbols in the top bar on the display on page 18 .
State of charge
There are 5 levels of charge for the
battery.
Battery fault.
Cable connection between the re-
mote control and the product.
There are 2 buttons for the information center display.
The left side button (C) moves to the next symbol in the
display. The right button (D) makes the selection.
Remote control batteries
WARNING:
control batteries and the charger, you must
read and understand
27 and Battery charger safety on page 27 .
Note:
It is necessary to charge the batteries before
you use the remote control for the first time.
Note:
Put the battery in the charger for approximately
10 seconds to start the battery if it is in sleep mode.
The remote control has 2 battery slots. Each battery
has a state of charge symbol on the display and the
information center display, refer to
bar on the display on page 18 and Information center
display on page 68 . It is not possible to operate the
remote control if the state of charge of the remote
control batteries is too low.
The operation time for fully charged remote control
batteries is approximately 12 hours. Cold weather can
decrease the operation time. If the display is used
frequently, the operation time can decrease.
If you do not use the batteries for 5 days, the batteries
go into shipping mode. The shipping mode saves energy
and the remote control cannot start to operate. When
the batteries are in shipping mode, you must connect
them to the charger for 10 seconds to exit shipping
mode.
Charge the remote control batteries each 6 months to
keep the quality of the batteries.
1401 - 005 - 11.01.2024
Symbol
Symbol
/
Before you use the remote
Battery safety on page
Symbols in the top
To remove and install the remote control
batteries in the remote control
Note:
It is necessary to charge the batteries before
you use the remote control for the first time.
Note:
Put the battery in the charger for approximately
10 seconds to start the battery if it is in shipping mode.
1. Turn the remote control to get access to the rear
side where the batteries are.
2. Remove or install the remote control batteries.
WARNING:
install the batteries with the poles in
the correct direction. There is a risk of
electrical shock.
To charge the remote control batteries with the
battery charger
The charging time for an empty remote control battery
is approximately 3 hours with the battery charger. When
you charge the remote control batteries, the temperature
must be between 10°C/50°F and 45°C/113°F.
1. Remove the empty remote control battery from the
remote control. Refer to
remote control batteries in the remote control on
page 69 .
Make sure that you
To remove and install the
69