Husqvarna DXR 95 Operator's Manual page 51

Symbol Color
Yellow
Red
• View the tabs (B)-(E) to show more information
about the temperature, the voltage, the current
and the performance of the product. Refer to
"Temperature" on page 51 , "Voltage" on page 51 ,
"Current" on page 51 and "Performance" on page
51 .
"Temperature"
• In the temperature tab you find information about
the current temperature of the AC motor and the
hydraulic oil.
"Voltage"
• In the voltage tab you find information about the
current voltage for each phase, the max. and min.
voltage since the product was started, and the
current grid frequency. In the voltage tab, the "load
voltage" is also shown. "Load voltage" is the lowest
measured voltage on the three phases when a tool is
used.
"Current"
• In the "Current tab" you find information about the
current in each phase, and the max. current since
the product was started.
"Performance"
• The percentage in the performance tab shows the
performance of the product.
100% Maximum performance.
The performance of the product is low-
99–80% er than usual because the product is
too hot.
The performance of the product is low-
50% er than usual because there is a fault
in the product.
The motor stops because the tempera-
25% ture of the product is higher than the
maximum temperature limit.
1401 - 005 - 11.01.2024
Description
Outside of limit values,
not critical.
Outside of limit values,
critical.
"Functions" menu (DXR 95)
Tools
Machine status
Functions
Controls
System
• The "Oil refill" fills the hydraulic oil. Refer to
hydraulic oil (DXR 95) on page 97 .
• The "Fill grease hose" fills the grease hose. Refer to
To fill the grease hose (DXR 95) on page 109 .
"Functions" menu (DXR 145, DXR 275, DXR
305, DXR 315)
Tools
Machine status
Functions
Controls
System
• The "Oil refill" fills the hydraulic oil. Refer to
check of the hydraulic oil level (DXR 95, DXR 145)
on page 93 and To do a check of the hydraulic oil
level (DXR 275, DXR 305, DXR 315) on page 93 .
• The "Track tension" engages the automatic track
To do automatic caterpillar track
tension. Refer to
tension (DXR 145, DXR 275, DXR 305, DXR 315) on
page 122 .
"Controls" menu
Tools
Machine status
Functions
Controls
System
"Joystick setup"
• In "Pattern" you can start a pattern test. Refer to
"Pattern test mode" on page 66 . You can also
change joystick pattern for the operation of the
remote control. Refer to
"Pattern 2" on page 57 , "Pattern 3" on page 60
"Pattern 4" on page 63 .
and
• "Side switch setup" sets the function for the 2 side
switches on the joysticks.
• "Auto": if "Extra function 1" is in operation, the
right side switch controls the function. If "Extra
function 1" is not in operation, the right side
switch has the same function as the top buttons
on the right joystick. If "Extra function 2" is
in operation, the left side switch controls the
function. If "Extra function 2" is not in operation,
the left side switch has the same function as the
Oil refill
Fill grease hose
To fill the
Oil refill
Track tension
To do a
Joystick setup
Calibrate hydraulics
Control diagnostics
"Pattern 1" on page 52 ,
51