Panasonic KX-T336 System Reference Manual page 569

Functions of various keys on the function keyboard
Function keys :
(Fl to F8)
LOOP keys :
(LOOP1 to
LOOP6)
RELEASE key :
ANSWER key :
HOLD key :
CANCEL key :
SPLIT key :
PAGE key :
ALARM key :
NIGHT key :
MSG key :
DIAL PAD :
(0 to 9, * #)
Programmable
There are 12 programmable keys on the keyboard, which can be assigned to be any
keys:
of 11 function keys listed below:
Functions of these keys vary according to the displayed screen.
Used to make and answer the calls (both extension and outside) etc..
Releases a call held on the LOOP key.
Used to answer incoming calls in first come first served basis.
Places a call on hold.
Cancels any key operation while holding a call on the LOOP key.
Switches between the SRC (Source) side party and DES (Destination) side party.
Used to execute parking a call and paging functions.
Displays major/minor alarm when the ALARM LED is flashing/lit.
Switches between day and night modes.
Used to leave a message on the LED of an extension which does not answer.
Used to dial the telephone number and the feature number.
AUTO, TRG, CALL-PARK, TOLL-CHG, ACCOUNT, SERIAL,
OHCA, CONF, REDIAL, E-E and One Touch (direct input)
Refer to 6-C-10.00 "Attendant Management Screen," for further information about
Programmable key.
PRG MODE
switch :
l
The attendant console is operable as call processing terminal and system
administration terminal by setting this switch ON and OFF.
l
When you set this switch to ON, the initial display of VT programming mode appears
on the screen.
Now you can operate the attendant console as the system administration device.
(System administration device name must be set to "ATT 1 or ATT 2" in the system
programming beforehand.)
. You can enter into Dumb programming mode by pressing I=]
key +
q
key
simultaneously at main menu screen of VT programming mode.
l
Set this switch to OFF, to return to the call processing mode.
6-A-3