Hitachi PC-ARFG-E Installation & Operation Manual page 53

SERVICE & INSTALLATION MENU
Element Optional function
Lock function for fan speed
FA
selection
Lock function for swing louver
Fb
operation
Lower limit of setting
temperature for cooling
FC
(Minimum value of setting
temperature allowed in
cooling)
Upper limit of setting
temperature for heating
Fd
(Maximum value of setting
temperature allowed in
heating)
FE Not used
FF Not Used
H1 Not used
Indication of hot start
H2 (No Indication of operation
limitation)
H3 Not used
H4 Not Used
J1 Not used
48 PMML0565 rev.0 - 09/2021
Individual
Settings
setting
00 Function disabled
X
01 Function enabled (factory setting)
00 Function disabled
X
Function enabled
01
(factory setting)
Function disabled
00 19ºC is the standard minimum set point
(factory setting)
01 +1ºC (Lower limit 20ºC)
02 +2ºC (Lower limit 21ºC)
03 +3ºC (Lower limit 22ºC)
X
· ·
· ·
· ·
08 +8ºC (Lower limit 27ºC)
09 +9ºC (Lower limit 28ºC)
10 +10ºC (Lower limit 29ºC)
Function disabled
00 30ºC is the standard maximum set point.
(factory setting)
01 -1ºC (Upper limit 29ºC)
02 -2ºC (Upper limit 28ºC)
03 -3ºC (Upper limit 27ºC)
X
· ·
· ·
· ·
10 -10ºC (Upper limit 20ºC)
11 -11ºC (Upper limit 19ºC)
12 -12ºC (Upper limit 18ºC)
00
- 01 -
02
00
O -
01
00
– -
01
00 Displayed
X
01 Hidden
00
– -
01 / 02
00 -
–
01 -
00
- -
01
Setting conditions Description
This function is used to prevent
changes to the fan speed.
This function is used to prevent
changes to the automatic louver
operation.
This function defines the lowest
temperature setting value for
FAN/COOL/DRY modes.
This function defines the highest
temperature setting value for
HEATING mode.
Models:
RPF(I)-FSN2E
up to 20ºC (FC=10)
Use at 00 conditions
Use as 00 conditions
Use at 00 conditions
This function is used to display
or hide the automatic control
indication.
Models:
RPF(I)-FSN2E
Not available, use at 00
conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions