Suzuki Jimny 2022 Manual page 274

OPERATING YOUR VEHICLE
(12) (11)
(10)
80T050460
3) Pull down the "RES/SET" switch (3) to
"SET –" position (5). When set speed
indication (10) and "SET" indicator (11)
appear on the information display, you
can run at the set speed or by following
the vehicle ahead.
WARNING
When you do not use the adaptive
cruise control, press the cruise
switch (1) to cancel the system. If you
activate the adaptive cruise control
by mistake, an accident may occur.
5-73
NOTE:
• Set the cruise speed not to exceed the
maximum speed specified by traffic
signs.
• Under the following conditions, you can-
not set the cruising speed.
– When the vehicle speed is less than
approximately 40 km/h (25 mph)
– When the gearshift lever is in "P", "R"
or "N"
– When the stereo camera is malfunc-
tioning or stopping temporarily
®
– When ESP OFF switch is pressed
– When the driver does not fasten the
seat belt
– When the driver's door is open
– When the parking brake is not
released
– When the brake pad is in high tem-
perature
– When driving on a steep slope
– When the transfer lever shifted into
"4L" position
– When the gear of automatic transmis-
sion remains in 1st gear for several
seconds
• If you turn the ignition switch to "ACC" or
"LOCK" position or press the engine
switch to change the ignition mode to
ACC or LOCK (OFF), the system will be
canceled automatically.
Checking vehicle ahead detecting indi-
cator
Vehicle ahead detecting indicator (12) has
two patterns of indications as follows,
depending on presence or absence of the
vehicle ahead.
A vehicle ahead is not detected. In this
case, your vehicle is in the state of con-
stant-speed control.
A vehicle ahead is detected. In this
case, your vehicle is in the state of
deceleration control and following con-
trol.
80TS - 01E