1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ratchet
10.
Install the belt guide on the idler arm
11.
Using the ratchet in the square hole, install the
idler spring
(Figure
Note:
Make sure that the spring ends are
seated in the anchor grooves.
12.
Install the belt covers
Figure 88
5. Square hole in the idler
arm for the ratchet
6. Idler-grease fitting
7. Belt guide
(Figure
88).
(Figure
89).
1. Position the belt cover
2. Slide the belt cover under
the side catches
g009038
Replacing the Hydraulic
Pump-Drive Belt
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
88).
operating position.
3.
Remove the mower belt; refer to
Mower Belt (page
4.
Raise the machine and support it with jack
stands
(Figure
58
Figure 89
3. Ensure that the tab is
under the metal catch
Replacing the
57).
90).
g027730