Adjusting The Scraper - Yamaha YS1070T Owner's Manual

2
1
1
B
2
A
2. Be sure to use the clean-out tool (lodged snow
remover) to remove snow and other obstacles from
the auger housing.
3.
Remove the locknut, the shear bolt.
3
1. Locknut
2. Shear bolt
3. Impeller
4. Install the new shear bolt and then tighten the new
locknut to the specified torque.
Tightening torque:
Locknut:
10 N·m (1.0 kgf·m)
NOTICE
• Tighten the locknut to the specified torque.
Shear bolt may be damaged if they are loosely
installed.
• Use genuine shear bolt only.

Adjusting the scraper

WARNING
Position the Snowblower on a level surface.
1. Stop the engine and remove the engine switch key.
2.
Loosen the nuts.
3.
Loosen the left and right bolts.
1. Scraper
2. Nut
3. Bolt
3
Periodic maintenance
5-16