Table of Contents
Advertisement
3
1
1
3
2
TIP
Adjust the left and right skids so they are both the
same height.
8.
Tighten the nuts of skid to the specified torque.
Tightening torque:
Nut:
16 N·m (1.6 kgf·m)
Replacing the auger shear bolts
WARNING
• Do not look into or put your hands near the
impeller or auger when they are rotating.
• When removing snow lodged in a rotating part
with the clean-out tool (lodged snow remover),
stop the engine, remove the engine switch key,
and wait until all moving parts have stopped.
• Position the Snowblower on a level surface.
• Wear gloves when using the clean-out tool
(lodged snow remover) to avoid injuries.
1.
Stop the engine and remove the engine switch key.
2.
Be sure to use the clean-out tool (lodged snow
remover) to remove snow and other obstacles from
the auger housing.
3.
Remove the locknuts, the shear bolts and the
3
washers.
1
1. Locknut
2. Shear bolt
3. Washer
1
3
4.
Install the new shear bolts with their washers.
5.
Install the new locknuts and then tighten them to
the specified torque.
Periodic maintenance
5-14
Advertisement
Table of Contents
