Table of Contents
Advertisement
Operation
Before Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Before Operation Safety
General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age or require certified training of
the operator. The owner is responsible for training
all operators and mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety decals.
•
Always engage the parking brake (if equipped),
shut off the engine, remove the key, wait for all
moving parts to stop, and allow the machine
to cool before adjusting, servicing, cleaning, or
storing the machine.
•
Know how to stop the machine and shut off the
engine quickly.
•
Check that the operator's presence controls, safety
switches, and shields are attached and functioning
properly. Do not operate the machine unless they
are functioning properly.
•
Locate the pinch-point areas marked on the
machine and attachments; keep your hands and
feet away from these areas.
•
Before operating the machine with an attachment,
ensure that the attachment is properly installed
and that it is a genuine Toro attachment. Read all
the attachment manuals.
•
Evaluate the terrain to determine what accessories
and attachments you need to properly and safely
perform the job.
•
Have the property or work area marked for buried
lines and other objects, and do not dig in marked
areas; note the location of unmarked objects and
structures, such as underground storage tanks,
wells, and septic systems.
•
Inspect the area where you will use the equipment
and remove all debris.
•
Ensure that the area is clear of bystanders before
operating the machine. Stop the machine if
anyone enters the area.
Fuel Safety
•
Use extreme care when handling fuel. It is
flammable and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
•
To prevent a static charge from igniting the fuel,
remove the machine from the truck or trailer and
refuel it on the ground, away from all vehicles. If
this is not possible, place a portable fuel container
on the ground, away from all vehicles, and fill it;
then refuel the machine from the fuel container
rather than from a fuel-dispenser nozzle.
•
Keep the fuel-dispenser nozzle in contact with
the rim of the fuel tank or container opening at
all times until fueling is complete. Do not use a
nozzle lock-open device.
Adding Fuel
Recommended Fuel
•
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 87 or higher ((R+M)/2 rating method).
•
Ethanol: Gasoline with up to 10% ethanol
(gasohol) or 15% MTBE (methyl tertiary butyl
ether) by volume is acceptable. Ethanol and
MTBE are not the same. Gasoline with 15%
ethanol (E15) by volume is not approved for use.
Never use gasoline that contains more than
10% ethanol by volume, such as E15 (contains
15% ethanol), E20 (contains 20% ethanol), or E85
(contains up to 85% ethanol). Using unapproved
gasoline may cause performance problems and/or
engine damage which may not be covered under
warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel
containers over the winter unless you use a fuel
stabilizer.
•
Do not add oil to gasoline.
15
Advertisement
Table of Contents
