Table of Contents
Advertisement
Engine-Oil Specifications
Oil Type: Detergent oil (API service SG, SH, SJ, or
higher)
Crankcase Capacity: with filter, 2.0 L (2.1 US qt)
Viscosity: See table below
Figure 36
Checking the Engine-Oil Level
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
3.
Open the hood.
4.
Clean the area around the oil dipstick
37).
Figure 37
1. Oil dipstick
5.
Pull out the dipstick and wipe the metal end
clean
(Figure
37).
6.
Slide the dipstick fully into the dipstick tube
(Figure
37).
7.
Pull the dipstick out and look at the metal end.
8.
If the oil level is low, clean around the oil-fill cap
and remove the cap
(Figure
2. Metal end
(Figure
38).
1. Fill cap
9.
Slowly pour only enough oil into the valve cover
to raise the level to the F (Full) mark.
Important:
with oil to prevent damaging the engine.
g000650
10.
Replace the fill cap and dipstick.
11.
Close the hood.
Changing the Engine Oil
1.
Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2.
Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
3.
Lower the loader arms, engage the parking
brake, shut off the engine, and remove the key.
4.
Remove the drain plug
g004172
1. Oil drain valve
5.
When the oil has drained completely, replace
the plug.
Note:
Dispose of the used oil at a certified
recycling center.
6.
Remove the fill cap
approximately 80% of the specified amount of oil
in through the valve cover.
32
Figure 38
2. Valve cover
Do not overfill the crankcase
(Figure
39).
Figure 39
(Figure
38) and slowly pour
g004173
g005556
Advertisement
Table of Contents
