Toro 22342HA Operator's Manual page 27

Opening the Hood
1. Loosen the hood-locking screw
Figure 25
1. Hood
2. Hood-latch lever
2. Turn the hood latch clockwise
3. Swing the hood up
4. Swing the prop rod up and secure it in the
bracket on the hood
Figure 26
1. Prop rod
2. Bracket
Closing the Hood
1. Pull the prop rod out of the bracket on the hood
and lower it into its holder.
2. Lower the hood and secure it by pushing down
on the front of the hood until it locks in place.
3. Tighten the hood-locking screw to secure the
latch (Figure 25).
(Figure 25)
3. Hood-locking screw
(Figure 25).
(Figure 25).
(Figure 26).
3. Hood
4. Prop-rod holder
Opening the Rear-Access Cover
1. Unscrew the 2 hand knobs securing the
rear-access cover to the machine
1. Hand knobs
2. Tilt the rear-access cover down and remove it to
access the internal components
g009691
Closing the Rear-Access Cover
1. Move the rear-access cover in place over the
back of the machine; ensure that the tabs line
up in the slots.
2. Push the access cover forward, lining up the
hand-knob screws with the threaded holes in
the machine.
3. Screw the hand knobs tight to secure the
rear-access cover in place.
Removing the Side Screens
1. Open the hood.
2. Slide the side screens
the slots in the front screen and frame.
g004184
1. Side screen
27
(Figure
Figure 27
(Figure
(Figure 28) up and out of
Figure 28
27).
g004185
27).
g004186