Craftsman IB-28140 Owner's Manual page 27

I AWARNINGI For accuracy in routing
i=,,= i and improved control,
the
workpiece should be held against the
router table fence when routing.
ADJUSTING THE FENCE
FACEPLATES (Fig. 28)
The right and left fence faceplates are
attached to the front face of the router table
fence and can be adjusted inward or outward
from the router bit to allow proper clearance
for different-sized bits. To provide the best
support during routing operations, the fence
faceplates should be as close to the bit as
possible without being able to come in contact
with the bit (typically about 1/4 in. from the bit
is a suitable distance).
1. Loosen the clamping knobs (21) and
carriage bolts (43) securing each fence
faceplate (19) and slide the faceplates
inward or outward from the router bit as
needed.
=0=° @ ® ¢®
Guard not shown for clarity
I _WARNING I Always hold the workpiece
against the router table
fence when routing. Such precautionary
safety measures increase the accuracy in
routing and improve the control of the
workpiece reducing the risk of personal injury.
2. Once the fence faceplates (19) are in
the desired position, tighten the clamping
knobs (21) and carriage bolts (43)
SECURELY.
27