Alternate Method - Craftsman IB-28140 Owner's Manual

METHOD 2 (Fig. 16)
1. Set the router table (A) on a workbench or other
stable and sturdy surface with the FRONT (switch
side) of the router table facing towards you.
2. While holding the router table in the desired
position, mark the location of the four mounting
holes (one in each leg [8 and 10]).
3. Remove the router table (A) from the
workbench and set it aside.
4. Drill suitable pilot holes (for wood screws) or
through-holes (for machine screws) at the
marked locations.
5. Place the router table (A) on the workbench
and align the mounting holes in the router table
legs (8 and 10) with the holes drilled in the
workbench.
6. Secure the router table (A) in place using the
wood screws and washers (not provided). If
using wood screws, applying a thin coat of soap
or wax to the screw threads will make it easier
to thread the screws into the pilot holes.
7. TIGHTEN all screws SECURELY.
Fig. 16
...... j/
................. _ ...... . ........... _T....
ALTERNATE METHOD 2
(Figs. 17 and 18)
1. Cut a board 18_A in. wide x 23 in. long from
a piece of 3/4-in.-thick wood or plywood.
2. Center the router table (A) on the board and
mark the location of the four mounting holes
(one in each leg [8 and 10]).
3. Remove the router table (A) from the
workbench and set it aside.
4. Drill suitable pilot holes (for wood screws)
or through-holes (for machine screws) at
the marked locations.
5. Place the router table (A) on the board and
align the mounting holes in the router table
legs (8 and 10) with the holes drilled in the
board.
6. Secure the router table (A) in place using
the wood screws and washers (not
provided). Applying a thin coat of soap or
wax to the screw threads will make it easier
to thread the screws into the pilot holes.
7. Secure the board to a workbench or other
sturdy surface with screws (Fig. 17) or
clamps (Fig. 18) during use.
iMPORTANT: Be sure the placement of
the clamps will not interfere with operation
of the router table.
Fig. 17
Fig. 18
18