Craftsman IB-28140 Owner's Manual page 17

TOOL BOXES (Fig.14)
Your router table (A) comes with two tool boxes
(9) with hinged covers. The tool boxes are
permanently mounted to the left and right leg
assemblies (8 and 10). Both tool boxes have
hinged covers with latching tabs on the front.
Please note the tool boxes are an integral part of
the leg assemblies and should not be removed.
Fig. 14
MOUNTING THE ROUTER TABLE TO A
WORK SURFACE OR WORKBENCH
Before operating the router
I -AkWARNINGI in the router table, ensure
that the table legs are fully extended and in 1.
the locked position, The entire unit (router
table with router) is placed on and secured to
a solid, flat, level surface that will not tip, Such
precautionary measures reduce the risk of table 2.
shifting unexpectedly while in use resulting in
property damage or serious personal injury.
HELPFUL TOOLS AND PARTS
(not included)
, C-clamps
, Phillips screwdrivers
, Small adjustable wrench
, Electric or hand drill with drill bits
(depending on mounting method used)
, Fasteners
-- 4 #10-16 x 3/4-in. pan-head wood
screws and 4 washers (for solid wood
surfaces or workbenches)
OR
-- 4 3/16-in. pan-head machine screws,
8 washers, and 4 hex nuts.
METHOD 1 (Fig. 15)
Set the router table (A) on a workbench
or other stable surface with the FRONT
(switch side) of the router table facing
towards you.
Using the clamping bosses on the router
table legs (8 and 10), secure the router
table legs to the workbench with clamps.
Be sure to tighten them securely.
iMPORTANT: Be sure the placement of
the clamps will not interfere with operation
of the router table.
Fig. 15
17