Advertisement
9. Loosely install the rear crosslink to the crosslink tubes
and rear plates using 4 carriage bolts (5/16 x 1-3/4
inches), 4 carriage bolts (5/16 x 3/4 inch), and 8 flange
nuts (5/16 inch) as shown in
Figure 10
1. Carriage bolt (5/16 x 3/4
inch)
2. Rear crosslink
10. Loosely install the front crosslink to the front plates
and corner gussets using 4 carriage bolts (5/16 x 1-3/4
inch) and 4 flange nuts (5/16 inch) as shown in
11.
Figure 11
1. Carriage bolt (5/16 x 1-3/4
inch)
2. Flange nut (5/16 inch)
Figure
10.
3. Carriage bolt (5/16 x 1-3/4
inches)
4. Flange nut (5/16 inch)
Figure
3. Front crosslink
11. Tighten all loose fasteners.
12. Install the 2 roof-support brackets to the crosslink
tubes using 2 self-tapping screws (1/4 x 1/2 inch) as
shown in
Figure
1. Roof-support bracket
2. Crosslink tube
13. Set the sunshade down.
14. Using the hole in the top of the roof-support bracket
as the template, drill a 7.9 mm (5/16 inch) hole on each
side of the sunshade
5
12.
Figure 12
3. Self-tapping screw (1/4 x
1/2 inch)
(Figure
13).
Figure 13
Advertisement
