Advertisement
5. Secure the lower bracket of the windshield support to
the left side of the machine using 4 carriage bolts (5/16
x 1 inch) and 4 flange nuts (5/16 inch) in the holes you
drilled in step
2 (Figure
Figure 6
1. Carriage bolt (5/16 x 1
inch)
2. Flange nut (5/16 inch)
6. Loosely install the rear tubes to the rear loop brackets
using 8 carriage bolts (5/16 x 2 inches), 2 mounting
plates, and 8 nuts (5/16 inch) as shown in
Figure 7
1. Carriage bolt (5/16 x 2
inches)
2. Mounting plate
6).
3. Lower bracket of
windshield support
Figure
3. Nut (5/16 inch)
7. Loosely install the left and right rear plates to the tubes
using 4 carriage bolts (5/16 x 1-3/4 inches), 2 backing
plates, and 4 flange nuts (5/16 inch) as shown in
8.
1. Carriage bolt (5/16 x 1-3/4
inches)
2. Rear plate
3. Backing plate
8. Loosely install the left and right front plates and corner
7.
gussets to the crosslink tubes and the left and right
windshield supports using 8 carriage bolts (5/16 x
1-3/4 inches) and 8 flange nuts (5/16 inch) as shown
in
Figure
1. Carriage bolt (5/16 x 1-3/4
inches)
2. Front plate
3. Corner gusset
4
Figure 8
4. Flange nut (5/16 inch)
5. Tube
9.
Figure 9
4. Flange nut (5/16 inch)
5. Crosslink tube
6. Windshield support
Figure
Advertisement
