Advertisement
Figure 2
1. Flange nut (1/4 inch)
2. Spacer (9/32 x 5/8 inch)
3. Left loop bracket
D. Repeat this step to install the right loop bracket
on the right side of the machine.
2. Using the dimensions shown in
(5/16 inch) into the outside of the floor plate on the
left and right sides of the machine.
Figure 3
4. Hex-head bolt (1/4 x 2-1/2
inches)
5. Flat washer (5/16 inch)
Figure
3, drill 2 holes
3. Using the dimensions shown in
(5/16 inch) into the outside of the footboard on the
left and right sides of the machine.
4. Secure the middle bracket of the windshield support to
the machine using 2 hex-flange bolts (5/16 x 1 inch)
and 2 nuts (5/16 inch) in the holes you drilled
5).
1. Windshield support
2. Hex-flange bolt
3
Figure
4, drill 1 hole
Figure 4
Figure 5
3. Nut (inside dash frame)
(Figure
Advertisement
