OLIGHT X7R Marauder - 12,000 Lumens Flashlight Manual

INSIDE THE BOX

X7R Marauder, Power adapter, USB Cable, Holster, Lanyard, User manual.

SPECIFICATIONS

Material: AL6061-T6 aluminum alloy unibody design with MilSpec Type-Ⅲ hard anodizing, along with blue bezel ring and stainless clamping ring on the switch

*Stated data on Turbo and High mode has been measured indoor under 20 degrees Celsius, windless laboratory conditions. The data may vary due to environmental and heat dissipation conditions.
NOTE:

1. Before your first use, please remove the protective film on the lens.
2. UNLOCK: When the light is already locked out, hold the switch for over two seconds until the light blinks. You will now be in the standard operation mode again.
   

CHARGING

The power of the built-in batteries can slowly drain during transportation or storage. For a better user experience, please charge the light before use to ensure that the battery has full power. The charging port is located at the tail of the flashlight. Twist the tail cap to open the charging port cover. Use the provided charging adapter and connect the flashlight via the provided USB Type-C cable. When the port glows red, it means it is being charged; when it turns green it means the flashlight is fully charged. Remove the cable and twist the tail cap to close the charging port before use.

NOTICE: The hold space will be expanded to 70mm when the blue dividing line is removed.

OPERATION INSTRUCTIONS

ON/OFF: Press the side switch to turn the light on/off. When the light is turned on again, it will return to the previous brightness level selected.

MEMORIZED MODES: Only nightlight, low, medium, and high mode can be memorized when the flashlight is switched off. High mode will only be memorized for 10 minutes and will then revert to the medium setting. Turbo and Turbo S will be memorized as high, and will revert to the medium setting after 10 minutes. Strobe mode is never memorized.

CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the side switch to automatically cycle through nightlight, low, medium, high and low modes. The mode is selected when the side switch has been released.

NIGHTLIGHT MODE: When the flashlight is off, press and hold the side switch for over one second to access the nightlight mode. When the flashlight is turned off and on again, it will return to the nightlight mode that was selected previously due to its memory function.

DIRECT ACCESS TO TURBO MODE: Double click the side switch quickly to activate the Turbo mode. Double click quickly again to access the Turbo S mode. You can double click the side switch to shift between Turbo and Turbo S mode.

STROBE: Triple click (or more than three times) the side switch quickly to enter the strobe mode. To quit this mode, single click or press and hold the side switch.

LOCK/UNLOCK: When the flashlight is off, press and hold the side switch to access the button lockout mode (the flashlight will enter the nightlight mode first and will then switch off to signal the lockout mode). Under the lockout mode, press and hold the side switch for less than two seconds without releasing it and the flashlight will enter the nightlight mode again. To unlock the flashlight, simply press and hold the side switch for over two seconds and release it to return to normal functionality.

TRIGGER THE MOTION SENSOR: Shock the flashlight by tapping it on a table, picking it up, or waving it. The indicator on the center of the side switch will light up and with a rhythm mimicking people breathing. If the batteries have enough power, the indicator will show green, and if not, it will show red. The indicator stops working when the light is in lockout mode.

USE OF LANYARD: Pull up the lanyard hole attachment on the flashlight body below the side switch and run the lanyard (with a diameter of less than 5mm) through this hole.

Do not turn the light directly into human eyes. This may cause blindness for seconds or hurt the eyes.

• Please only use the provided adapter for charging this product. Use of other adapters may result in damage to this product.
• Do not use the Turbo S mode continuously when the environmental temperature is high in case the flashlight body is too hot to hold.
• Do not cover or shade the front of the flashlight when it is under high brightness working status. The energy given by the beam could result in overheat, melting or burning.
• There are drainage holes designed in the tail cap of the light. When this product is immersed in water, the water will not get into the interior body but will accumulate at the inner compartments of the tail cap. In this case, do not open the charging port cover. When removing the flashlight from water, shake the light to remove any built-up water in the tail cap.

WARRANTY

Within 30 days of purchase: Return to retailer from which you purchased for repair or replacement.
Within 5 years of purchase: Return to Olight for repair or replacement.
Battery Warranty: Olight offers one year warranty for all rechargeable batteries.
This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an Authorized retailer or Olight itself.

Technical Support Inquiries
techsupport@olightworld.us
Customer Service
customer-service@olightworld.com,
cs@olightworld.us
Visit www.olightworld.com
to see our complete product line of portable illumination tools.

Olight Technology Co., Limited
Address: 5th Floor, Building A2,
Fuhai Information Harbor,
Fuhai Subdistrict, Bao'an District,
Shenzhen, China 518103
V2. 17, 08, 2017
3.0502.6010.9992