OLIGHT S2 BATON - 950 Lumens LED Flashlight Manual

INSIDE THE BOX

S2 Baton, battery magazine, lanyard, manual.

SPECIFICATIONS

Material: 6061-T6 aluminum alloy structure, Type III hard anodizing, stainless steel pocket clip.

OUTPUT & RUNTIME

BATTERY INSTALLATION

Ensure battery is inserted with the positive (+) end pointing to the tailcap. The flashlight will not operate with incorrectly inserted battery.

SUPPORTED BATTERIES

• 1 x 18650 or 2 x CR123A

HOW TO OPERATE

ON/OFF: To turn on the light, single-click the side switch, the flashlight outputs at memorized brightness level, single-click again will turn the light off.

CHANGE BRIGHTNESS LEVEL: Press and hold the side switch when the light is on. The output will cycle through low – medium – high – turbo mode. Release the side switch when the desired brightness level is achieved.

MOONLIGHT: From off state, press then hold the side switch for 1 second enables the low-lumen moonlight.

DIRECT ACCESS TO TURBO: From off state, double clicks directly activate turbo mode.

STROBE: While on, triple-click the side switch to activate strobe mode, any other operation will quit the strobe.

TIMER: The light contains two timer settings: long timer (9minutes) and short timer (3 minutes). Double click the side switch to enter this setting. short timer blink once for 3 minutes, long time blink 2 times for 9 minutes. Double click the side switch to change the timer to the opposite setting. The light will automatically shut off when the timer is over.

WARRANTY

Within 30 days of purchase: Return to retailer from which you purchased for repair or replacement.

Within 5 years of purchase: Return to Olight for repair or replacement.

This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an Authorized retailer or Olight itself.

Do not turn the light directly into human eyes. This may cause blindness for seconds or hurt the eyes.

• Do not use the turbo mode continuously when the environmental temperature is high in case the flashlight body is too hot to hold.
• Ensure battery is inserted with the negative (-) end pointing to the head of the flashlight (LED side).
• If the light is about to be put aside for a long time or be transported, please unscrew the tail cap lightly to cut off the circuit of electricity.

Olight Technology Co., Limited
Address: 2/F, Building A, B3 Block, Fuhai Industrial Park, Fuyong, Bao'an District, Shenzhen, China 518103

V1. 10, 31, 2015 MADE IN CHINA

www.DrMemory.com/Olight